Aladdin-light-lift ALL200-CM-240V Bedienungsanleitung

ALL200-230V INSTALLATION INSTRUCTIONSAladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www.alad

STEP 23Adjust screw collar rings so top of canopy is just below edge of bottom contact plate. Canopy should be at least 4.4cm deep. See Diagram I.Nev

STEP 27Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory. S

ALL200 TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm US CSTI. Troubleshooting and installation must be per

ALL200 TROUBLESHOOTING GUIDE cont. 1. Conrm ALL200 is at the CEILING POSITION. If not, use the controller to operate the ALL200 to the CEILING POSI

Read the following guidelines prior to installing the ALL200:I. e ALL200 must be installed by a licensed, bonded and insured electrician. II. e ALL

STEP 1Determine where ALL200 will mount on ceiling joists. ALL200 must be installed level, in an accessible location directly above chandelier.Never

STEP 5Attach the 1/2” conduit connector on ceiling box to bottom of conduit assembly. Once completely inserted, tighten set screw on conduit connecto

STEP 7Position ALL200 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate assembly should hang down through ceiling h

STEP 9Shim and adjust ALL200 so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Diagram E. Look up at c

STEP 11Turn o supply power before wiring ALL200. Turn o motor switch in square box. Wire motor switch with 230V wiring. e 230V motor feed must be

STEP 13Remove dust cover by using 5/16” nutdriver or socket. Remove paper tape from winch drum while keeping tension on winch cable.Never operate the

STEP 20Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS(13mm) xture coupler. If chandelier was supplied